Cellulose is the principle fiber of the cell wall of coffee. It is partially ordered (crystalline) and partially disordered (amorphous). The amorphous regions are highly accessible and react readily, but the crystalline regions with close packing and hydrogen bonding may be completely inaccessible. Native cellulose, or cellulose 1, is converted to polymorphs cellulose III and cellulose IV when exposed to heat. Coffee's structure is a well developed matrix enhancing the mass uniformity and aiding in the even propagation of heat during roasting. Cellulose exists in coffee embedded in lignocellulose (an amorphous matrix of hemicellulose and lignin containing cellulose), making up the matrix cell walls. Hemicellusloses are polysaccharides of branched sugars and uronic acids. Lignin is of special note because it is a highly polymerized aromatic. Severe damage occurs to the cell walls of the matrix at distributed temperatures above 446 degrees F and bean surface temperatures over 536 degrees F The actual temperature values will change due to varying levels of other constituents. Second crack, associated with darker roasts, is the fracturing of this matrix, possibly associated with the volatilization of lignin and other aromatics. Under controlled roasting conditions, the bean environment temperature should never exceed 536 degrees F. A wider safety margin would be achieved by limiting the maximum environment temperature to 520 degrees F. These temperature limits minimize damage to the cell matrix and enhances cup complexity, roasting yield, and product shelf life.